Water Flow Sensor Flowmeter 20-500 L/min (3 Inches) DN80

Aluminum body Water flow sensor. Flow meter that detects the flow of liquids from 1 liter per minute, up to 120 liters per minute. Internally it has a magnetic field Hall effect sensor that detects the movement of the blades that is generated with the passage of the liquid. Delivery to the output square pulse signal whose frequency corresponds to the flow of the liquid. Rugged mechanical design, convenient for 3 "inch piping and environmentally friendly encapsulation, easy to use. TECHNICAL CHARACTERISTICS Water pressure = 1.75MPa (Max) Input flow from 20 to 500L / min ± 3% Working voltage 4.5-15V CD (Red wire) Maximum current 15mA (5VDC) Insulation resistance> 100M ohm Inlet and outlet tube: 3 inches Material: Aluminum Body; PA66 Nylon turbine; SUS304 steel Axes Frequency of flow Hz (vertical detection) F = 0.05 * Q Where Q = liters / min where Q is water flow Working temperature -20 ° C to + 60 ° C High pulse output> 4.7V (5V input voltage) (Yellow wire) Low pulse output <0.5 V (input voltage 5V) The duty cycle of the output pulses of 50% ± 10% A flowmeter is an instrument used to measure flow or volumetric flow of a fluid. Its mechanical parts consist of a mill with blades transverse to the flow circulation, which has at one end a permanent magnet. When this magnet rotates it generates a variable magnetic field that is read by a magnetic field effect sensor (Hall effect sensor), then the electronic circuit converts it into pulses that it transmits through a cable. This type of flowmeter magnets are installed at the ends of the blades. When turning the magnets pass near a network switch that detects the pulses. The sensor must be connected to a pulse counter as it transmits Voltage square pulses through the yellow wire. Applications: -automatic water dispensers -Water Purifiers -flow control

• Water pressure up to 1.75MPa (Max) - Input flow from 20 to 800L / min ± 3%
• Working voltage 4.5-15V CD (Red wire) -- Maximum current 15mA (5VDC)
• Inlet and outlet tube: 3 inches (DN80) -- Material: Aluminum Body; PA66 Nylon turbine; SUS304 steel Axes
• Frequency of flow Hz (vertical detection) F = 0.05 * Q Where Q = liters / min -- where Q is water flow
• High pulse output> 4.7V (5V input voltage) (Yellow wire) -- Low pulse output <0.5 V (input voltage 5V) -- The duty cycle of the output pulses of 50% ± 10%