1pcs Circular Saw Blade Cutting Disc Tool CNC Slot Machining Tungsten Carbide Steel 50-70MM Diameter Metal Cutting (60mm-d16.2mm)

Saw Blade (1PCS) NOTICE: It is required to use with the tool holder that is NOT INCLUDED in this link; please click the image below to purchase it if necessary. Material: In general, combined with full tungsten steel, cutting iron as mud, using special steel lattice mixed processing, shock resistant, wear-resistant, high temperature resistant, long service life. High gloss double sided mirror effect, good gloss. Overall leveling design, smooth surface, smooth and efficient cutting. Treatment: Accuracy: Inner hole--+0.01~0.02 Outdoor--±0.02 Sawing: Sawtooth precision grinding processing, scientific angled design, sharp and smooth machining, no burnt board, no rolled edge, no burrs. The thinner the saw blade, the more sensitive it will be to vibrations and tensile stresses when used. If there is radial or axial offset, it is easy to cause damage. Bad. Therefore, the milling machine must operate in a stable state, that is, the machine tool has high precision, good cutting rod rigidity and stable transmission. Amount of food per tooth Constant and sufficient cooling. The specific requirements are as follows: <;0.02mm, axial deviation 0.01mm. 2. As long as the milling depth of the milling cutter is not affected, clamp the two sides of the blade on the cutter rod with a large flange plate as much as possible, to eliminate vibration and avoid lateral compression. Generally, the diameter of the flange plate is not less than 1/3 of the outer diameter of the saw blade. 3. Reasonable linear milling speed Vc and feed speed Sz per tooth should be selected. Generally, under the same conditions, the hard alloy saw blade milling cutter can choose Vc faster than the high-speed steel saw blade milling cutter, but the feed speed per tooth should be lower than the feed speed of high-speed steel. Sz can usually be set between 0.005 and 0.025/tooth. Specific parameters must be determined by the user according to the speed of the milling machine, the properties of the milling, thickness, number of teeth, milling depth and other factors are determined. VC: P: 70~150, 50~80 k:80~120 m:70~120 N:200~350 Sizes: 20~50 Outside Diameter--Cutting Depth 40mm--3mm 50mm-- 5mm 63mm-8mm 70mm--10mm 75mm--12mm 80mm--15mm 100mm--20mm 125mm--30mm ========== Chemical highly concerning: None is_customized: Yes Origin: Mainland China Finish: white. Model Number: sawmill Blade Material: Tungsten Carbide Steel Size: 40mm Number of pieces: 1 piece Blade Type: Circular Saw Blades Use: Commercial manufacturing Teeth: 72

• Size: 50-70MM
• Number of pieces: 1 piece
• Blade Type: Circular Saw Blades
• Use: Commercial manufacturing
• Teeth: 72