ITW Red Head LDT-3830 3/8 x 3 Large Diameter Tapcon (LDT) Anchor 50 Per Box by LARGE DIAMETER TAPCON
Product details
| Management number | 215655484 | Release Date | 2026/04/12 | List Price | $34.15 | Model Number | 215655484 | ||
|---|---|---|---|---|---|---|---|---|---|
| Category | |||||||||
ApplicationsThe anchor is made from Grade 5 Carbon Steel, and is Zinc Plated. This anchor is designed for use in Concrete, Block, and Brick.EnvironmentThe anchor is designed for use in a Dry environment.Head Style The anchor is a Hex Washer Serrated head and is designed to allow the head to sit on top of the surface of the item being attached.Hole Diameter/Bit DiameterThe anchor requires a 5/16" hole to be drilled in the base material (Concrete, Block, and Brick). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.Driver RequiredA 9/16" nut driver is required for driving the anchor into the base material.Diameter of Anchor The diameter of the anchor is 3/8".Length Anchor The length of the anchor is 3"Thread LengthThe length of the threads on the anchor is in length.Minimum EmbedmentThe minimum anchor embedment into the concrete is 1-1/2". Therefore, the anchor must be installed so that a minimum of 1-1/2" of the anchor is embedded into the concrete.Maximum Fixture ThicknessThe maximum fixture thickness or the maximum thickness of the material being fastened for a anchor is 1-1/2". This will ensure that the minimum embedment of 1-1/2" will be met.Fixture Hole DiameterThe hole in the fixture or material being fastened must be larger than the designated diameter of the anchor. The 3/8" diameter anchor requires the hole in the fixture to be 7/16".Spacing between AnchorsEach anchor must be spaced a minimum distance of 6" from each other when measured center to center.Edge DistanceIt is very important not to install the anchor any closer than 3" from an unsupported edge of the concrete.
- FASTER INSTALLATION - More than 2x faster installation than wedge or sleeve anchors
- HARDENED GRADE 5 STEEL - Superior holding values
- SERRATED HEX WASHER HEAD - Prevents back-out
- SINGLE PIECE DESIGN - No assembly required; ready to install
- STANDARD ANSI BIT - Simplicity with confidence LDT will hold as expected
| UPC | 798167816922 |
|---|---|
| Brand | Tapcon |
| Color | Silver |
| Set Name | LDT-3830 3/8 x 3 Large Diameter Tapcon Anchor Set (50 Pieces) |
| Head Type | Hex |
| Size Name | 3/8 |
| Metal Type | Zinc,Carbon Steel,Steel |
| Unit Count | 50.0 Count |
| Part Number | LDT383:2 |
| Thread Size | 3/8 |
| Thread Type | Ldt |
| Drive System | External Hex |
| Finish Types | Zinc Plated |
| Grade Rating | grade_ 5 |
| Manufacturer | ITW Red Head |
| Thread Class | LDT |
| Thread Style | right hand partially threaded |
| Fastener Size | 3/8 x 3 |
| Item Diameter | 0.38 Inches |
| Material Type | Carbon Steel |
| Exterior Finish | Zinc,Steel |
| Thread Coverage | Partially Threaded |
| Number of Pieces | 50 |
| Screw Head Style | Hex |
| Screw Point Style | Sharp |
| Set Screw Thread Type | Lag Thread |
| Compatible Groove Diameter | 0.38 Inches |
Correction of product information
If you notice any omissions or errors in the product information on this page, please use the correction request form below.
Correction Request Form