Ortur Laser Master 2 Belt Tensioners
Product details
| Management number | 502064 | Release Date | 2025/07/09 | List Price | $19.20 | Model Number | 502064 | ||
|---|---|---|---|---|---|---|---|---|---|
| Category | |||||||||
This set of 3 Belt tensioners for the Ortur Laser Master 2 (LM2) let's you adjust the belt tension on your DIY laser printer. COMES WITH 3 BELTS AS WELL.
Finally you can achieve perfect tension :)
Hand tighten or hand loosen the threaded knob to make the adjustment.
DO NOT OVER TIGHTEN YOUR BELTS!!!
Please refer to this video for tension
/watch?v=yAFyZZX8RUk&feature=youtu.be
You may need to Replace your belts with longer belts, to see if your belts are long enough-
You need to remove the washers that previously Locked your belt on the side that you install the tensioners
X belt needs to be at least 625mm
Y belt needs to be at least 640mm
These are the minimum if you are cutting belt off a roll leave a little extra
Bestseller ranking
Burning
Correction of product information
If you notice any omissions or errors in the product information on this page, please use the correction request form below.
Correction Request Form